Manufacturer: Fisher Scientific
Model: Isotemp Small Incubator with optional Hybridization
Fisher Isotemp Hybridization Incubators are designed to process nucleic and protein blots derived from hybridization procedures.
Incubator heat is accurately controlled to precisely maintain the chamber temperature. Temperature can be set between slightly above ambient and 85°Cand is easily set by simple controls on the front panel. A large, bright display shows actual temperature during operation. The incubator features keypad protection, which prevents the set temperature from being changed. This is useful when setting up a processing program where the unit will be unattended. An offset temperature can be programmed to compensate for the actual temperature inside a typical sample loaded into the tubes. The incubator can monitor and store the maximum deviation of the actual temperature from the set temperature. Temperature deviation can be monitored and saved during processing and recalled later.
A separate safety thermostat limits the incubator temperature to approximately 95°C in the event of a temperature controller failure. An indicator on the front panel shows when this condition exists.
For Hybridization option:
A rotisserie holds the sample tubes and rotates to provide membrane coverage. Rotisserie rotation speed can be varied by a knob on the front panel. A jog control permits rotating the rotisserie in steps to insert and remove tubes. The incubator has a glass door for observing samples during processing.
Interior surfaces are stainless steel for high durability and low maintenance. Small and medium same size units are stackable with an optional stacking plate. The small incubator can be mounted under a cabinet or counter with the optional mounting bracket
- 4 of the 35x300 mm sample tubes
- 8 of the 35x150 mm sample tubes
- 2 of the 70x300 mm sample tubes
Power Requirements: 1.8 A @ 230 VAC
230 VAC ±10%, 50/60 Hz
Ambient conditions: +16 to 40°C, up to 90% relative humidity, non-condensing
Temperature range: Ambient +7 to 85°C
Average uniformity: ±0.5°C at 55°C within the chamber; ±0.25°C at 55°C sample to sample
Heat-up time: 20 minutes from ambient to 65°C
Rotisserie speed: 5-15 rpm
Maximum altitude: 2000 m
Over-voltage category: II (IEC 664)
Pollution degree: 2 (IEC 664)
Dimensions (W x L x H): 18 x 16.5 x 17 inches (46 x 42 x 44 cm)
Weight: 45 lbs (21 kg)
- Fisher Scientific Isotemp Incubator
- Power cord
The incubator is in used but good cosmetic condition and is 100% functional tested